# IPv4 Specific Configuration File
#

# Allow everything over loopback (lo ::1/28)
# Good idea to keep this turned on, but if you so wish to,
# you can disable it here.
# Values: no | yes (default)
AllowAllv6Loopback="yes"

# Very early on rules to allow for trusted machines to access
# this machine.  Rather important and helps keep you from getting
# locked out should the firewalling rules go bad.
#
# IMPORTANT:  Hosts put in the trusted file will have complete
# and unfettered access to the host, ignoring all other rules.
#
# Config file: ipv6/trusted.conf
# Values: no | yes (default)
EnableTrustedv6Hosts="yes"

# Enable MSS clamping to work around MTU size issues
# on network links such as PPPoE and wireless
# Config file: ipv6/mss-clamp.conf
# Values: no | yes (default)
Enablev6MSSClamp="yes"

# Use /etc/resolv.conf as source for DNS servers that we communicate
# with as a client.  If you turn this off (recommended if on static IP),
# then you will need to manually define the DNS servers you use.
# Without conntrack rules allowing established/related, DNS traffic may
# be blocked and cause issues.
# Values: no | yes (default)
DNSClientUsev6ResolvConf="yes"
ResolvConfv6File="/etc/resolv.conf"

# Uncomment below if you set above to no.  You can still manually define your servers
# here if you want.  Useful at times.
# Values: space separated IP list of DNS servers
#DNSClientManualv6Servers=""

# Enable the EasyBlock access list
# This is a simple/easy way to block traffic in or out,
# no complex options.  Use the Filter options for more
# complex ACLs
# Config file: ipv6/easyblock.conf
# Values: no | yes (default)
Enablev6EasyBlock="yes"

# Enable IPv6 filtering rules
# This allows you to define complex access control list /
# filtering rules.
# Config file: ipv6/acl.conf
# Values: no | yes (default)
Enablev6Filtering="yes"

# Enable IPv6 NAT/NETMAP rules
# This allows you to set up NAT rules, SNAT, MASQ, and NETMAP
# Config file: ipv4/nat.conf
# Values: no | yes (default)
Enablev6NAT="yes"